I'm looking forward to my pair arriving soon!
All the orders via PM have been sent out so should be with you soon!
I've done a little guide to assembling these bots. How hard can it be to stick two haves together? My advice is don't use superglue. The instant bond it gives will mean you have no time to position the halves together. If you make a mistake with sugerglue and the halves don't match you will not get them apart for a second go! Here's my method.
1. After cleaning up the edges of the bots get some epoxy. I use this brand from poundland in the UK. Works great.
2. Score the bottom of each half with a needle or scalpel. Sand down any ridges this leaves.
3. Use blu tak to stick one half down onto a coin or something similar that will keep the bot level as the epoxy cures.
4. Mix the epoxy and spread the thinnest possible amount onto both halves. This has to be a super thin coating or else epoxy will seep out of the
sides. Even the thinnest amount will form a super strong bond. Once together you get a few minutes to possition the halves correctly and also have time to match the halves if you're gluing more than one bot.
Hope this helps!!
cheers
Iain