Lead Adventure Forum
Other Stuff => Workbench => Tutorials => Topic started by: Alfrik on 10 November 2009, 05:17:48 PM
-
I decided to do away with the short pieces of cast roadways I used and make full board length pieces from Kel Seal Brush and Trowable Caulking. Starting with a blank pine board to be the model work space, I laid down to pieces of 2 inch masking tape with a slight overlap on to the board. 3 Thin coats of the KS brushed and dried, I pulled up slowly on the tape, turned the entire road section over. The 3 thin coats had dried and curled the cross section slightly up, so that with the road section turned upside down, the edges cupped downwards nicely. One more thin coat of the KS brushed (using 3" cheap disposable brush), let dry. I then slowly tore off any tape still showing to give the road a rough and then with one brown wash coat of acrylic paint to finish the surface off. Care should be used not to get the KS off the edge of the tape, or it tends to stick to the work surface and be a bit difficult to peel up. Total time spent actually applying KS to the tape for the road was about 10 min tops, with an hour between each coat while I worked on other figures and such.
Pics: http://armoredink.blogspot.com/2009/11/roadway-update.html
I have a permanent storage case that holds up to 6 foot long sections, but the roads are very very flexible (basically dried painting caulking) and can be stored by being rolled around a card board tube section or tin can.
-
Using the same procedure that I used to make roads, I am now trying out for making water ways. The first attempt gives a nice Fast moving Water effect.
http://armoredink.blogspot.com/2009/11/fast-river-really.html
2 smoothish coats of kel seal caulk was brushed on, followed by the 3rd being smooth, but then dabbed with the 3" wide brush to finish it up. A sharp blade shaved the dried spikey bits from the dabbed areas to improve the look over all, then a wash of blue paint.