Lead Adventure Forum
Miniatures Adventure => Old West => Topic started by: roninrmz on September 16, 2011, 01:32:24 PM
-
looking to scratch build one any templates or advice on how to approach this? Ive been using white wash city and fat dragon games buildings for templates but neither offers a 5 side building.
-
Arnica Montana used to...
And Old Glory makes:
A Bank http://oldglory25s.com/images/MW111.jpg Well, I guess it's more like 6. lol
and a saloon. http://oldglory25s.com/images/MW205_Palace-Saloon.jpg Well, the bottom level is 5 sided...
-
So do Dixons and Hovels.
-
thanks for the response ive seen these I was looking more for directions on how to make one.
dimensions and figureing out how to determine length width etc.
-
Try PM'ing RUSHCAL.
He makes some wicked buildings. Two of which are 5 Sided Saloons. Well 1 painted two different ways..... ;)
Check out http://leadadventureforum.com/index.php?topic=28055.msg339458#msg339458 (http://leadadventureforum.com/index.php?topic=28055.msg339458#msg339458)
and http://leadadventureforum.com/index.php?topic=18323.msg220820#msg220820 (http://leadadventureforum.com/index.php?topic=18323.msg220820#msg220820)
-
Try PM'ing RUSHCAL.
He makes some wicked buildings. Two of which are 5 Sided Saloons. Well 1 painted two different ways..... ;)
Check out http://leadadventureforum.com/index.php?topic=28055.msg339458#msg339458 (http://leadadventureforum.com/index.php?topic=28055.msg339458#msg339458)
and http://leadadventureforum.com/index.php?topic=18323.msg220820#msg220820 (http://leadadventureforum.com/index.php?topic=18323.msg220820#msg220820)
Seconded, they are good value for money too!
-
Are you trying to make a pentagon shaped one (all sides equal) or an odd shaped one ,the easyest way for the latter is to remove a corner from a four sided one and replace it with a fifth side at a 45`angle to the other walls.
For a pentagon shape I would draw out five lines radiating from a centerpoint at 72`angle intervals and use the drawing to figure out the size of walls needed the inside angle of connecting wall should be 108`degrees if i remember my geometry correctly,Hope this helps
-
thanks that does help looking to make an odd shaped building