Lead Adventure Forum
Other Stuff => Workbench => Topic started by: Argonor on 27 December 2016, 02:45:35 PM
-
I do not own a 3D-printer, otherwise I would have made this from plastic.
As it is, it had to be made the old-fashioned way, scratch-built from card-stock.
(https://1.bp.blogspot.com/-KPcU_gjntQw/WGJzGbQwASI/AAAAAAAAHIk/b_DsbVRbHQkCt1154vdfanlKCX1I98mzwCLcB/s640/2016_12_27-Card_Shoe_Armada_Small-01-500.JPG)
This was made for the Star Wars Armada Damage Deck (it is very tall, because I have two starter sets, and dunno if I am going to use both at a later point).
I am already working on an improved design (not the final one though), involving more glue, and possibly less scotch tape, for my Strange Aeons Solo Play Deck.
My blog contains a few more details on the matter - but I intend to do a more comprehensive guide later - so don't be disappointed by the lack of detailed information at this point.
-
The above was sized to hold FFG Yellow Sleeves - here is one to fit FFG Grey Sleeves:
(https://1.bp.blogspot.com/-qN7hNhse4Bs/WGVKkkgVP3I/AAAAAAAAHKA/yrOsZiTdRJUGLwHvFJHsCb5Pq7KQq0c8gCEw/s400/2016_12_29-Card_Holder_FFG_Grey_01-02-600.JPG)
View from the back shows some of the cardboard tabs I used to assemble the deck holder.