Lead Adventure Forum
Miniatures Adventure => The Second World War => Topic started by: Fitz on December 07, 2018, 04:08:52 AM
-
(https://3.bp.blogspot.com/-4dY9qAARQsw/XAnsHTwWSiI/AAAAAAAAMKk/j9XHxhtO8swVrBDZ3FWT4U9BCQ7ZczScwCLcBGAs/s1600/2018-12-07-a10.jpg)
This is a pair of 3d printed 1:100 scale British WWII A10 Cruisers, along with some 15mm Battlefront BEF figures in my sabot bases. The model is by m_bergman (I think), very slightly modified by me.
There are some definite issues with these prints: the side shields didn't print, I suspect because they were too thin, and I got a bit of warping on the turret base, a problem I haven't had to deal with for months. Also, on one of them there is a slight layer shift with associated under-extrusion, and what might have caused that I don't yet know. However, neither of them is so poor that it needs to be binned, and they'll do fine on the wargames table.
I am going to have to do a bit of tinkering with my printer though, to get it back to printing properly again.
-
They look perfectly acceptable to me. Nice brushwork to boot.
-
Nice.