Lead Adventure Forum
Other Stuff => Workbench => Topic started by: Digits on January 21, 2021, 04:58:16 PM
-
So I have just bought a small pla printed greenhouse from Iron Gate Miniatures.....but I will be damned if my Loctite superglue will stick it together!
Anyone have sure fired way of pluming PLA parts please?
-
Plastic Weld (or some other derivation) but allow it to go off properly and be quite liberal with it.
-
I shall look for some, thanks.
-
Apply it with a brush (squirrel hair brushes are good as they hold quite a bit) but keep that brush separate from painting brushes.
It’s not great stuff so be careful with it :)
-
Might not work in fine details, but for a PLA printed mini that I'd gotten a while back, I powdered one side with some baking soda and used super glue applied to the other side then used a bit more around the joint
-
I have used Pastruct Plastic Weld to glue SLA prints successfully.
It glues them like it would a plastic model kit.