The AVGP family

[Dr_oz]

AVGP Grizzly goes to test print
This is an early version (with a wave reflector and screws), there will be another version without a shield and with boxes instead of screws. Variants of the armored personnel carrier have been made with an open and closed driver's hatch, as well as two versions of the commander's hatch (in the original, by the way, it should rotate) and two versions of the turret (again, an open and closed hatch). As usual, I make variants of the model where the body and wheels are both as one unit and with wheels separately.
Now the task is to check the model during 3D printing

[Pattus Magnus]

Very cool! The training base near where I grew up used to have several Grizzlies. I always looked for the “tanks” as a kid whenever we would drive past.

These will work great in Cold War gone hot forces!

[Dr_oz]

The test print revealed a couple of shortcomings.
Overall I'm pleased with this model.
A HUGE thank you to Ilya for the amazing print quality!!!
Scale, as usual, 1:100

[Dr_oz]

Very cool! The training base near where I grew up used to have several of Grizzlies. I always looked for the “tanks” as a kid whenever we would drive past.

These will work great in Cold War gone hot forces!

Thank you! Very pleased to hear!

[Dr_oz]

AVGP Cougar is over.

[Daeothar]

Wonderful work! 


Is it me, or is the printed commander in the Grizzly looking rather big though?

[Dr_oz]

Wonderful work! 


Is it me, or is the printed commander in the Grizzly looking rather big though?

Thank you for such a nice review!
In the photo with Grizzly there is a figure from BF