Hey guys,
as said in the subject line. What do you use to cut perfect round holes into plastic card?
Me, I use a compass (or pair of compasses) used for technical drawings. It is set with two spikes and I use it to slowly scrape away the plastic until the inset comes loose.
Needless to say that this methods leaves much to be desired.
For once it takes ages to get through the plastic card especially if it is a tad on the thicker side and on top of that if you get impatient and start to apply too much pressure you risk warping the plastic card.
Any good advice is welcome and thanks in advance.
von der Tann