Scratch built or converted 18mm Scifi vehicles

[zrunelord]

Hello again,
These are failed 3d prints . All are PLA. Used card, other 3d printed parts etc to make something out of them , instead of throwing them away.

https://castrarunis.blogspot.com/2022/08/scratch-built-or-converted-18mm-scifi.html















Thank you for your comments
Z

[Golgotha]

I do like the armoured car.

[War Monkey]

A few very interesting vehicles, I like to see how they turn out when your finish.

[CookAndrewB]

Always keep the failed prints! I make wrecks or salvage as you did. It really isn't that hard.

Any idea why the prints failed?

[has.been]

A few very interesting vehicles, I like to see how they turn out when your finish.

Me too!

I was wondering why more people don't offer failed prints. I have picked up
some scenery like that. Some creeping vines (buildings) tarpaulins (machinery)
etc. & they do good service on the table.

[zrunelord]

Thank you all,

WM, soon (ish ) 

Golgotha, the orange ones are from Antenocities but kitbashed. Quite nice models.

Cook, yes indeed. The 2 orange failed due to bad supports ( I had just started 3d printing ),  The bus ( the one with mostly card top ) due to a clogged nozzle  & the last one due to a roof cave in ( due to 2 layer only top part ). Mistakes which could have been avoided. Still I enjoy scratchbuilding by hand so it's still a win. The one thing I wish I could suss out in resin printing is how to angle a model to avoid layers showing. It doesn't show that much in 18mm but I wish I could solve it.

Has been, Yes indeed & as they say one man's rubbish is another's treasure..... & we would reduce waste also which is always an open sore. 

Z