Copplestone Gardner gun - construction help!

[JollyBob]

Has anyone ever put one of these fellas together? I just won one off eBay, but I think there may be a bit missing. 

Does the gun sit on a pintle or mounting on the carriage, as there seems to be a space for one, and a hole under the barrel assembly, but there's nothing to put in there. The picture on the website's no good as a guide as the wheel and gunner's arm obscures the part I need to see.

If there is a bit missing, would a piece of brass rod do instead or is it really noticeable?

Any help, anybody? Thanks muchly if you can.     

[Dewbakuk]

If nobody can help before this evening then I'll try and take a photo of the bits etc. Have to wait until then though.

[JollyBob]

Ta. 

[Malamute]

Here you go, here's mine.
my gunner is in the wrong place though, but you can see the mount for the gun:

[JollyBob]

Ah, I see, thanks very much mate.

So there is a pintle mount missing. No probelms, I should be able to knock one of them up out of brass rod and green stuff.

Cheers! 

EDIT: Actually, thinking about it, since there are two armament options, which is which? I had asssumed that the Gardner gun was the larger of the two but I really can't see much to tell them apart except that one appears o have extra barrels. 

[Malamute]

Mine has the Gardner gun, because my Nordenfeld was missing its handle. The Nordenfeld is the smaller of the two with the covered magazine.

[JollyBob]

A missing handle? Did you get yours off eBay too? 

Thanks for that, I was going to use the bigger one anyway because its.. uhm... bigger... (I blame too much 40k as a youngster)