Blacks Post Apoc Buildings

[mikedemana]

I've never seen that in any of the craft stores around me. Thanks for the recommendation. I DO use the fancy scrapbook paper that Hobby Lobby and Michaels carry. One of them is corrugated brown. (https://www.hobbylobby.com/Scrapbook-Paper-Crafts/Paper-Cardstock/Specialty-Paper-Single-Sheets/Corrugated-Cardboard-Scrapbook-Paper---12-x-12/p/111173)

Are the ones you're getting off Amazon paper, also? Or are they plastic?

Mike Demana

[BlackMetallic]

Paper, they cut easily with a scissor (or hobby knife).  I was going to try peeling carboard, but this is 90000 times easier!

[BlackMetallic]

Working more on painting trucks the past week than buildings, but my pile of "to be finished" is growing.   I found a bunch of 1/100 scale WW2 armored cars and they upscale to 25-28mm really well without detail loss.  I've been busy "apocalypsing" them.

[BlackMetallic]

Slow night at work, (work at home) so I can knock some junk walls out.

[BlackMetallic]

Got 15" of "junk wall" built.  One 6" section, three 3" sections.

[CapnJim]

They look good so far....

[BlackMetallic]

Used my preferred priming method - Flat Red/Brown, Barbarian Skin, then Pale Flesh (rattle can).  Ready for paint in about 20 minutes.

[mikedemana]

Great start! I have never taken the leap to spray painting my stuff (other than spray primer for terrain and the occasional miniature that needs reinforcement). Kudos to you to finding a way to get things done even quicker!

Mike Demana

[Constable Bertrand]

Junk walls look great! 

[BlackMetallic]

Finished the "set" of walls, primed and ready for paint.