Panzer 35(t) (15mm)

[Fitz]

This is the troop of 1:100 (15mm) Panzer 35(t) that I printed on my new Mars Pro in the last couple of days. They're probably finished, unless I'm overcome with enthusiasm to paint on some more markings, which is fairly unlikely.





These three took a little bit under six hours altogether to print, and probably about the same again to prepare and paint. Their turrets are connected to the hulls by the magic of magnetism.

They're pretty rubbish on the wargames table, even in 1940-41 games, but I like them for their rivets. These rivets are a lot more prominent than they were on the real-life vehicles; they benefit much from artistic licence.