Silent Invader's Build: Urban Stream/Sewer (5/1 - with miniature)

[Christian]

I came across the perfect material for your trolley, and for wire fences. It comes from portable gas stoves... it's a very fine mesh that I picked up in a camping store. I was thinking about how you could make this on the way into work this morning... If you made a template that folds up into the shape of a trolley (like you make a cardboard cube in primary school) you could add a few more details with armature wire etc. I'm sure you'll find a way to put it together but I thought that mesh would have been perfect!

[Alfrik]

Always like to see other peoples take on swampy water.

[Furt]

This looks great - very promising.

I assume this will be used to showcase your your Scavenge Skirmish Survive line?

Will that "pipe" be open for playing in?

[Andym]

Great start!! Is the length of cream pipe going to be an cut away sewer?

[Damas]

If you have a belt sander and some time, you can just clamp the pipe in a workbench or workmate and run the belt sander along it until you achieve the profile you want. (Cue the noise, dust and required facemask!)

[Malamute]

How many combinations are there for putting the boards together to create different layouts?

 

[Malamute]

 

 

I bet there's at least one spreadsheet for this

[Elk101]

In which case the answer is........ 48 


[/quote]

That's still 6 more than the Ultimate Answer to Life, the Universe and Everything.

This will be really good to watch, it's already picked up a following!

[Centaur_Seducer]

[Mason]

Looks like it is progressing really well.

Not sure about the giant bog roll, though.
That may be going a tad too far!

[smokezombie]

Not all of us are lucky enough to have a terrain making table in the WC   

[Damas]

Steve,

You mentioned using a trolley in your sewer and so I knocked this one up.


Here is another shot


If you're interested?

[Hammers]

Effing brill.I would, though, solder a thin wire onto the upper edge of the trolley to make it look complete.

[Damas]

Effing brill.I would, though, solder a thin wire onto the upper edge of the trolley to make it look complete.

It only took ten minutes so I was just using what I had to hand.

[Blackwolf]

Great work SI,and clever stuff Damas.This comp is going to be a bit of an knockout I think!