I finally managed to sort out my Flikr account so I could upload a few more photos. So, I've been fiddling with a few things recently. Apologies for the size of the post...

First up, some HMMVWs (Revell - they seem more 1/76 than 1/72 to be honest):





An Airfix Jeep done as a rusty barn find:


A trailer (from the Airfix Jeep set):

Some barrels (Sgts Mess I think):

Haybales (the undercoat of yellow was waaaaay too yellow so it's fairly obvious where it shows through the jute bits - although to be fair it's more obvious on camera than in person)


Some Hornby telegraph poles - these were absolutely smooth so roughed them up with a hacksaw blade to get some texture:

A couple of ATVs from the always amazing Elhiem (incidentally, I ordered some new spec ops figures from them recently, and some backpacks and whatnot as stowage for the tanks, and they were a little bit delayed (due to Covid, so fair enough and not an issue) and as an apology they included an additional spec ops figure in the order - they are as amazing as the quality of their figures, and really great communication from them. Will continue buying from them and heartily recommend them to everyone)

Some scrappy barbed wire sections - made from Javis barbed wire, I think:

A barn for the barn find jeep and various bits to go in. This was scratch built from Wills corrugated roof and brick sheets, and some H beam from Plastruct. I learnt during this exercise that "oh, the nearest degree or two will be fine for the angles, I'll sort it with some sanding and filler" doesn't work.








Et voila. Next are the M2 and M1 - they're painted, just need filter, wash, weathering and stowage (so a fair bit, then).