Thanks guys.
V-02 gets it's cross bar, a tricky little piece. The plastistrip is too thick for bending, I briefly considered thinner and laminating it, in the end I did this thickness but added a little milliput to the inside corner. I let it set and then shaped it with the wrong end of a file to give an inside curve. None of this can be seen in the photo... :blush:

Slatting on V-05 the short uprights at the rear are not that well fixed, luckily there's tons of stowage to follow which will make all stronger.

Slatting on V-04, although this has a canvas top there is slatting underneath that. Had to make sure the slatting was far enough away from the vehicle edge to allow for this, and do similar to V-05 to make them look similar.
