Life in the vault is about to change:Modiphius minis pics 8/12

[Anpu]

Thanks everyone for your comments!

[DELTADOG]

Great Table Anpu! Really great Table!

[Anpu]

Thanks!

[Anpu]

Next up
Mirelurks
[/url]
Radscorpion

Bloodbug (Heresy Waspquito)

What's this then...

Hermit crab in a Vault Tec van

[clanmac]

I bow down before your 3D mastery - these are just ace!

[Anpu]

I wish there was any skill involved. The files are extracted from the game and resized. A few of them have adjustments to make them more printable.

[nedius]

How much are the lurks costing to print out? Not asking to buy, just curious as to how much per mini. 3D printing is something I may explore oneday myself.

And how much cleaning work is needed?

[Muzfish4]

Marvellous - this thread just gets better and better!

[Anpu]

Thanks for the comments!
The cost in materials is low. Time is the greater cost I would say.
As for clean-up I would say 20-30 minutes per model to remove the support material etc. The mirelurks are printed at 60 microns layerheight. I have yet to try the smallest nozzle which can get the layerheight down to 20 microns. This would increase printingtime considerably though.

[Dr Mathias]

That crab in the vehicle is just too cool.

[beefcake]

Where is the Deathclaw from? Is that a print from the game also? It looks great. You have done an amazing job with these!

I'm also assuming you mean microns (micrometres) rather than nanometres?

[Anpu]

It is a print from the game.  Yes I mean microns to tired  I guess.

[Exiledadmiral]

Awesome models. Loving the hermit crab in the van. Is that in the game somewhere? Might be time to head back into the wastes I think!

[King Arthur]

Some nice stuff going on here! Sorry if I missed this info, the Super Duper Mart, is that scratch built or the one from Sarissa?

Cheers

[Anpu]

Some nice stuff going on here! Sorry if I missed this info, the Super Duper Mart, is that scratch built or the one from Sarissa?

Cheers

It is the one from Sarissa