Now that Salute is out of the way, and my Dune terrain project completed, I've decided to move a couple of my existing projects along - starting with Battlestar Galactica.
First up, I'm not happy with my previous effort...its just too small. To put this into perspective, it was 10' long x 4' wide... ok so not small, but not quite big enough. In particular the flight pods aren't big enough - originally 6' long (in 3 sections) but only 1' wide, with 2 forward-facing launch tubes, and a single lift to/from the landing deck.
I've therefore decided to build a new starboard flight pod which will be 6' (in 4 sections) but 55cm wide, ie almost twice as wide - the new design incorporates 4 viper launch tubes, rather than 2, plus 2 lifts, instead of a solitary one on the previous design - crucially though the added width also means that I can show the flight deck, which I've situated above the launch tubes/lift.
(Photo shows the original flightpod, with the new boards underneath)

The added benefit of the wider boards, is that the launch tubes are now on the side of the pod, rather than the front (vipers are MkVII - OOP kits)


I've also added a 1:48 Viper MkIV to my collection (very OOP - based upon the failed Desanto/Singer revival project - effectively a heavily armoured viper).

Rear Flight Deck entrance visible top left hand corner of photo

Launch tubes will be on the rear two sections, with the lifts on the forward two sections (for viper recovery & to launch raptors)


Needless to say, if anyone has a 1:48 Viper, Raptor, or cylon raider they'd like to sell, I would be very interested...
